Newport-brass 6-027 Manuel d'utilisateur télécharger pdf

INSTALLATION INSTRUCTIONS

AIR GAP

Model No: 6-027

Recommended Installation by a Professional Plumbing Contractor

Note: The use of petroleum base plumbers putty on our products will nullify the warranty. We recommend the

use of clear silicone sealing materials. Recommended deck thru hole Ø 1.25" to Ø1.38

1. INSTALLING FAUCET TO AIR GAP

(See Fig 1)

Note:

Air gap assembly will replace the escutcheon and utilize the o-ring provided with faucet.

· Place the faucet inlet and mounting stud through air gap assembly, o-ring and mounting surface hole.

· Slide mounting cresent over mounting stud on underside of mounting surface and secure into place with mounting nut.

2. ATTACHING WATER SUPPLY CONNECTION

(See Fig 2)

· Slide the 1/4” OD R/O water supply tube (not included) through compression nut and compression sleeve. Place insert into end

of tube. Insert the end of tube into faucet inlet and thread compression nut onto the end of inlet.

· Connect 3/8” OD black tube (supplied) to drain saddle or drain clamp (not included) in waste drain. The waste drain should be

installed above the p-trap on the vertical section of the tailpiece. Keep this tube on a down hill slope from the faucet, tighten firm-

ly so tube will not pull out of drain clamp. Cut off excess tube if necessary.

Note:

This is a gravity fed line, if there is any bend or dip in the tube, the rinse water will not flow into the drain properly.

Water will back up and come out the air gap hole in the back of the faucet base.

· Connect 1/4” OD black tube (supplied) to Reverse Osmosis filter system drain (not supplied).

TEST INSTALLED FAUCET

· With handle in OFF position, turn on water supplies and check all connections for leaks.

(949) 417-5207

NWP-6-027 Santa Ana, CA 92705 10/10/2011

www.brasstech.com

Faucet

Escutcheon &

O-ring

Figure 1

Mounting surface

& hole

Mounting

Cresent

Mounting nut

Air gap assembly

Re-use faucet

o-ring

Faucet inlet

Insert

1/4” OD Tubing

(not included)

Compression

sleeve

Compression

nut

3/8”OD

black tubing

(included),

connect into

waste drain

Connect to R/O

water supply

(not included)

1/4”OD

black tubing

(included),

connect to

R/O filter

system drain

Figure 2

6-027 & 6-291

Résumé du contenu

Page 1 - Figure 2

INSTALLATION INSTRUCTIONSAIR GAPModel No: 6-027Recommended Installation by a Professional Plumbing ContractorNote: The use of petroleum base plumbers

Commentaires sur ces manuels

Pas de commentaire

Newport-brass 6-027 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la maison Newport-brass 6-027. Newport Brass 6-027 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la maison Newport-brass 6-027